Arizona MVD CDL General Knowledge Practice Test 5
Test 5 of 5. Pick an answer for each question to see if it is right and why; your score appears at the end. You need 40 correct answers to pass, the same ratio as the real Arizona test.
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. What is checked about the clutch and the gearshift during the in-cab inspection?
Show answer
Answer D: That the clutch free play is within the range the manufacturer specifies
Too little or too much clutch free play causes slipping or dragging, either of which can leave the driver unable to select the gear a hill demands.
-
2. Loading heavy freight on top of lighter freight has what effect on the vehicle?
Show answer
Answer B: It raises the center of gravity and makes a rollover more likely
A high center of gravity lets the vehicle tip more easily in curves or during a sudden swerve.
-
3. During a trip you stop for a break. Which items should you check before driving on?
Show answer
Answer B: Tires, wheels and rims, brakes, lights, reflectors, electrical connections and cargo securement
Critical items can change during a trip, so each stop is used to recheck the tires, wheels, brakes, lights, connections and cargo.
-
4. Which document must be available to show that the annual inspection was carried out?
Show answer
Answer C: The inspection report or a copy of it, or a decal displayed on the vehicle
Proof of the periodic inspection travels with the vehicle, either as the report itself or as the decal fixed where an inspector can see it.
-
5. You must leave the vehicle parked on a slight grade. What adds security beyond setting the parking brake?
Show answer
Answer D: Chocking the wheels so the vehicle cannot roll if the brake bleeds off
Chocks hold the vehicle mechanically and are the standard backup whenever a parked vehicle could roll.
-
6. You miss a gear while double clutching and the transmission is stuck in neutral. What should you do?
Show answer
Answer B: Return to neutral, release the clutch, bring engine speed to match road speed and try again
Forcing the lever damages the gears; matching the engine speed to the road speed lets the gear engage cleanly on the next try.
-
7. What are the Arizona minimum ages for a commercial learner permit?
Show answer
Answer A: 21 in general, or 18 for an intrastate permit valid only in Arizona
Arizona sets 21 as the general minimum age for a commercial learner permit but allows applicants who are at least 18 to obtain an intrastate permit that is valid only within Arizona.
-
8. What does the suspension system weight rating tell the driver?
Show answer
Answer A: The maximum weight that the manufacturer says the suspension can carry
Like tires and axles, suspensions have a manufacturer capacity, and loading beyond it can damage springs and air bags.
-
9. Under federal rules, what is required of a commercial driver who wants to use a mobile phone while driving?
Show answer
Answer B: The phone must be hands-free and started with no more than a single button press, and it must not be held
Federal rules ban texting and hand-held phone use while driving a commercial vehicle; reaching for, holding or dialing a phone is a violation.
-
10. You are strapping down a load with sharp metal edges on a flatbed. What should you use?
Show answer
Answer D: Edge protection between the strap and the sharp edges so the tiedown is not cut
Sharp edges cut or wear through a strap under tension, so edge protectors are required wherever a tiedown could be damaged.
-
11. Who must sign a driver vehicle inspection report?
Show answer
Answer D: The driver who prepared it
The report is the driver statement about the condition of the vehicle at the end of the day, so the driver signs it.
-
12. Why is driving much slower than the rest of the traffic dangerous?
Show answer
Answer B: Other drivers must keep passing you, which creates conflicts
Traffic that has to work its way around you produces lane changes and closing speeds, which is why a large speed difference is itself a hazard.
-
13. What must the driver check about the seat belt during the inspection?
Show answer
Answer A: That it is securely mounted, adjusts properly and is not ripped or frayed
A belt only restrains the driver if its anchorage is sound and the webbing is intact, so mounting and condition are both checked.
-
14. Which of these is a suspension defect you must look for during the walkaround?
Show answer
Answer D: Cracked or broken spring leaves, loose or broken U-bolts, or leaking air suspension bags
Broken springs, failed U-bolts and leaking air bags let the axle shift or the body drop, which can make the vehicle impossible to control.
-
15. You are about to slow down sharply on a highway to make a turn into a narrow driveway. How can you warn the drivers behind you?
Show answer
Answer C: Tap the brake pedal a few times so the brake lights flash before you slow down
A few light taps flash the brake lights and give following drivers an early warning that you are about to slow or stop.
-
16. You are told a posted bridge ahead has a weight limit lower than your gross weight. What must you do?
Show answer
Answer C: Take a route that avoids it, because a posted limit is a legal limit
A posted structure limit must be obeyed exactly as any other weight limit, so a heavier vehicle has to be routed around it.
-
17. Why must the downshift be finished before you reach a steep downgrade or a sharp curve rather than during it?
Show answer
Answer D: Because once your speed is too high you may not get into any gear at all
If you wait until speed has built up, the lower gear may refuse to engage and you can be left in neutral with no engine braking at all.
-
18. You are stopped in traffic on a steep upgrade behind another truck. How much space should you leave in front?
Show answer
Answer A: Enough that you can pull away without rolling back into the vehicle behind you
Room ahead lets you get moving smoothly on a grade instead of having to hold the vehicle perfectly still or roll back toward the traffic behind.
-
19. An unblocked crate 4 feet long and weighing 1,500 pounds needs at least how many tiedowns?
Show answer
Answer A: Two
A short article that weighs more than 1,100 pounds requires at least two tiedowns even though it is under 5 feet long.
-
20. Regular mirror checks during a long trip can reveal which developing problem?
Show answer
Answer D: Smoke coming from a tire or from a wheel
Overheating tires, wheel bearings and brakes usually show as smoke long before anything appears on the dash, and mirrors are where a driver sees it.
-
21. Under federal safety rules, what must the driver of a commercial vehicle do before starting a trip?
Show answer
Answer A: Be satisfied that the vehicle is in safe operating condition
The driver is responsible for inspecting the vehicle and must be satisfied it is in safe operating condition before the trip begins.
-
22. You want to check whether a tire on your truck is properly inflated. What is the correct method?
Show answer
Answer A: Measure the pressure with a tire gauge
Only a tire gauge tells you the actual pressure; a tire can look and sound normal while being badly underinflated.
-
23. On the Interstate System, what is the federal maximum weight allowed on a single axle?
Show answer
Answer A: 20,000 pounds
Federal limits for the Interstate System cap one single axle at 20,000 pounds.
-
24. How does a front tire failure usually feel to the driver?
Show answer
Answer D: The steering suddenly becomes heavy and pulls to one side
A failed front tire loads the steering and makes the wheel feel heavy, while a rear tire failure shows up as the back end swaying.
-
25. You are dropping a loaded trailer in a yard. How far should the landing gear be lowered?
Show answer
Answer A: Until the pads make firm contact and the trailer weight is just off the fifth wheel
Cranking down until the gear is firmly on the ground and just lifting the load off the fifth wheel makes the trailer stable and lets the tractor pull out cleanly.
-
26. You normally pull an empty trailer, but today the same tractor is loaded to its legal maximum. What changes about getting under way?
Show answer
Answer A: You may need to start in a lower gear, since the load takes more pulling power
The heavier the load, the lower the gear needed to get the vehicle rolling without lugging or stalling the engine.
-
27. A driver snores heavily, stops breathing briefly during the night and is tired all day despite long hours in bed. What should be suspected?
Show answer
Answer B: Sleep apnea
Sleep apnea repeatedly interrupts breathing during sleep, so the driver never gets true rest and stays dangerously drowsy during the day.
-
28. Within total stopping distance, what exactly is perception distance?
Show answer
Answer D: The distance traveled from the moment your eyes see a hazard until your brain identifies it
Perception distance covers only the time between seeing a hazard and recognizing it as a hazard, before any physical reaction begins.
-
29. Why does extra weight make a long downgrade more dangerous even when the brakes are in good order?
Show answer
Answer B: Gravity adds to the momentum and the brakes heat up faster
The heavier the vehicle, the more energy the brakes must turn into heat, and heat is exactly what makes brakes fade on a long descent.
-
30. Why do cracked spring hangers or badly worn shackles matter?
Show answer
Answer A: They allow the axle to shift out of its correct position under the vehicle
Hangers and shackles hold the spring, and therefore the axle, in place, so when they fail the axle can move and the vehicle may become uncontrollable.
-
31. The scale shows that your combination is over the legal gross weight. Why will sliding the tandems not fix it?
Show answer
Answer B: Because sliding the axles changes where the weight sits, not how much there is
Repositioning axles redistributes weight between axle groups; when the total is too high, freight has to come off the vehicle.
-
32. A 40 foot straight truck and a 70 foot tractor-trailer make the same right turn. Which needs more room and why?
Show answer
Answer B: The tractor-trailer, because the longer the vehicle the farther inside the rear wheels track
Off-tracking grows with the distance between the front and rear axles, so the longer combination cuts the corner much more sharply and needs extra room.
-
33. When is tire pressure most accurately compared with the recommended figure?
Show answer
Answer B: When the tires are cold, before the vehicle has been driven
Recommended pressures are cold pressures, so a reading taken before the tires have heated up is the only one that can be compared directly.
-
34. You have finished a lane change in a vehicle whose turn signal does not cancel by itself. What must you do?
Show answer
Answer D: Turn the signal off yourself
A signal left running tells other drivers you are about to move again, and they may act on that false information.
-
35. What is axle weight?
Show answer
Answer C: The weight carried to the ground by one axle or one set of axles
Axle weight describes how the load is shared among the axles that carry it to the road, not how much the whole vehicle weighs.
-
36. You are loading lengths of large diameter pipe on a flatbed. What is needed besides the tiedowns?
Show answer
Answer D: Chocks, wedges or cradles that keep the pipe from rolling
Anything that can roll must be prevented from rolling by chocks, wedges, cradles or a similar device that is itself secured so it cannot come out.
-
37. The coolant temperature gauge climbs above its normal range on a long grade. What is the correct response?
Show answer
Answer C: Stop when it is safe to do so and find the cause before going on
Rising coolant temperature signals a fault such as a lost belt, a leak or a blocked radiator, and continuing can turn a repair into a destroyed engine.
-
38. You are asked to drive a truck loaded with enough hazardous materials to require placards. What must you have?
Show answer
Answer C: A hazardous materials endorsement on your commercial driver license
Driving a vehicle that must be placarded requires the H endorsement, which involves a separate knowledge test and a security background check.
-
39. You are unsure whether your vehicle will fit through a narrow gate. What should you do?
Show answer
Answer A: Stop, get out and look, and take another route if the space is not clearly enough
Clearance is never guessed at from the seat; you look at it on foot and go round rather than trying a gap that may be too tight.
-
40. Total stopping distance is made up of which parts?
Show answer
Answer A: Perception distance, reaction distance and braking distance
The vehicle travels while the hazard is recognized, while the driver moves to the pedal, and again while the brakes slow the vehicle.
-
41. Where are the OVERSIZE LOAD signs normally carried on a vehicle moving under such a permit?
Show answer
Answer A: On the front and the rear of the vehicle
The warning signs face the traffic that meets the load and the traffic that comes up behind it, so they go on the front and the rear.
-
42. Which set of emergency equipment must be carried on a commercial motor vehicle?
Show answer
Answer D: A fire extinguisher, spare electrical fuses unless the vehicle has circuit breakers, and warning devices
The required kit is a properly charged and rated fire extinguisher, spare fuses when the vehicle uses them, and warning devices for a stopped vehicle.
-
43. What are you looking for when you check the drive belts in the engine compartment?
Show answer
Answer C: That each belt is snug and free of cracks, frays or heavy wear
A loose or cracked belt can break and stop the fan, the water pump or the alternator, which leads quickly to overheating or a dead electrical system.
-
44. How is free play in the steering wheel measured during the inspection?
Show answer
Answer B: By turning the wheel until the front wheels just start to move and noting the movement
Play is the movement at the rim that produces no movement at the road wheels, so it is measured by turning until the wheels first respond.
-
45. What do the U-bolts on a leaf spring suspension do?
Show answer
Answer A: They clamp the spring assembly to the axle so it cannot move
U-bolts hold the spring pack tight against the axle, and a loose or broken U-bolt lets the axle slide out of place under load.
-
46. Where should a trailer be dropped, and what else does the driver do before pulling out from under it?
Show answer
Answer C: On solid level ground, with the trailer wheels chocked if it may roll
A dropped trailer must sit on ground that will carry the landing gear without sinking, and chocks stop it rolling once the tractor and its air supply are gone.
-
47. You are not certain that your loaded vehicle will clear a low overpass. What should you do?
Show answer
Answer A: Take another route rather than risk it
There is no safe way to guess at a clearance, and striking a bridge endangers everyone on and under it, so the only correct choice is a different route.
-
48. You are given a ratchet strap with a deep cut along one edge. What should you do?
Show answer
Answer C: Do not use it; a damaged tiedown cannot be relied on to hold its rated load
Cuts, burns, knots and broken stitching weaken a strap far below its marked working load limit, so it must be taken out of service.
-
49. You have a part load that fills only a third of a long trailer. How should it be placed?
Show answer
Answer C: Spread out and centerd side to side, so the weight sits over the axles
A part load is spread over as much of the floor as possible and kept centerd, so no axle is overloaded and the vehicle stays balanced from side to side.
-
50. What is required of the hooks, rails, rings and anchor points that tiedowns attach to?
Show answer
Answer A: They must be part of the vehicle and strong enough for the load being secured
A tiedown is only as strong as what it is hooked to, so anchor points must be proper vehicle fittings rated for the job.